1, driving whirl cavity check whether the observation Keep doors to prevent materials from the whirl cavity observation out of the door, are dangerous.

2, check the impeller rotation direction from the direction I expected to see. Impeller should be clockwise rotation, it should be adjusted electrical wiring.

3, crusher and conveyor equipment for the start-up sequence:

→ nesting material to the crusher →

Crusher must empty start to be broken machine was operating normally before the feed.

Boot and shutdown sequence in reverse order.

4, feed particles in strict accordance with regulations to prohibit access to materials provided more than crusher Otherwise, the imbalance will cause impeller impeller and excessive wear and tear, to a plug-and center-channel impeller feeding tube so that the machine can not be broken normal , found large feeding should be immediately removed.

5, nesting stop moving equipment, should be expected to stop in time, otherwise, this will result in crushing the impeller, burning motor.

6, feed to continuous and uniform.

7, vsi crusher operation process, the vibration may be severe and unusual noise, it should stop checks.

8, machinery lubrication

Lubricating oil for lubrication, a Mobil motor Run fat premium, the amount of 1/2-2/3 for bearing cavity, the crusher each work group, adding some grease.

9, Common Faults and exclusion method:

No.
  Fault and defect characteristics
  Reasons
  Removal Method
 
1
  Product size too big
  The Pine Belt
  Tensioner bolt-tight
 
2
  Body Swing
  Feeding size too big
  Feeding regulation size
 
Impeller channel plug material
  Remove channel blocking material
 
Wear-resistant grinding caused biased towards the block
  Complete replacement of wear-resistant
 
3
  Metal crash
  Feeder collided with the impeller
  Feeder adjustment at the installation location